![]() ![]() Switches must be switched off to use thoseĭirect sunlight or lighting (of an inverter type ofįluorescent lamp etc. The power to the component connected to the Improper position (AX-592 and AX-892 only). Set the PHONO (MM/MC) switch to the proper No connection from the turntable to the GND The cable polarity is reversed at the amplifierįirmly connect the cables. Incorrect setting of the BALANCE control. Turning the unit off and then on will reset the The protection circuit has been activated The jumpor pins (PRE OUT/MAIN IN) are notĬonnected properly. Scribd is the worlds largest social reading and publishing site. Set the SPEAKERS switch, which corresponds Yamaha AX 592 Service Manual - Free download as PDF File (.pdf), Text File (.txt) or read online for free. Select an appropriate input source with the The appropriate input source is not selected. Rear panel is not set to the upper or the lowerĬonnect the cables properly. English AX-592 Turntable Tape deck 1 Tape deck 2 Speakers A LINE OUT LINE OUT Right Left LINE IN. : CONNECTIONS CONNECTIONS Before making any connections to or from this unit, first switch it and any other connected components. Set the switch to the upper or the lower end To assure the finest performance, please read this manual 13. The AC power plug is not plugged in or is not If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the AC power plug and contact your authorized YAMAHA dealer or service center for help. If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |